Auria mixer and MIDI mapping

[Corey W]

I just tested the setup again, here are the steps I am using

1) Turn on iPad> Turn on Bluetooth

2) Launch Auria Pro

3) Turn on nanoKontrol Studio (To battery mode) while holding down the Scene and Rewind (two arrows pointing left) buttons

4) Go into the Auria Settings> MIDI tab

5) Press the 'Bluetooth MIDI' button and connect the nanoKontrol Studio

6) In the Core MIDI i/o select Receive and Send Remote for the nanoKontrol

7) Change 'Remote Protocol' to Mackie HUI

Go back to the mixer screen and test the controls on the nanoKontrol Studio

[Qwimby Wun]

Corey,
Thanks for the friendly advice. I followed it closely but my NKS still goes offline 2 seconds after I select HUI. I'm convinced I got a bad one. I'm going to send it back. I have no complaints about Auria Pro tho. It's fantastic.