Noob using a bus

[seachord]

I'm pretty much a noob to DAWs and Auria, but slowly getting there...

Here is what I'm trying:

I have a short clip on track 1, and am sending it to Bus 1. Then track 2 gets its input from bus 1 so I can send it through an effect, and record it on track 2. However this doesn't work as I always get a track of silence. When I just loop it, the clip does go thru the effect... I just can't record it. Where have I gone wrong?

[Tovokas]

Assuming I'm understanding what you're trying to do correctly, to 'print a track to tape' with its effects, you don't need to use a buss. Simply put the effect on track 1, then solo the track, tap on menu/mixdown and make sure that 'import as new track' is selected. This will create a new track with the effect rendered. If you want to render a buss' output, simply solo the tracks going into the buss, and the buss itself, and use the same mixdown technique.

[seachord]

Tovokas - Thanks! Think I may have been thru this once before... Maybe it will "stick" this time!