I am using a powered USB hub, a Behringer X32 and an iPad air 2 with Aurora and I am unable to get the two to sync. Auria stays in INT mode instead of switching to USB mode. I have both set at 48Hz I have the Behringer and Auria set at 16 in and 16 out USB, in Aurora recording latency set to 4096 and still there is no connectivity between the two.
What am I missing here.
iPad Air2 with Auria and Berhringer x32 don't see each other
-
- New Member
- Posts: 2
- Joined: Sun Feb 15, 2015 9:36 pm
iPad Air2 with Auria and Berhringer x32 don't see each other
Last edited by Russhunt717 on Tue Mar 03, 2015 2:02 pm, edited 1 time in total.
-
- New Member
- Posts: 2
- Joined: Sun Feb 15, 2015 9:36 pm
Re: iPad Air2 with Auria and Berhringer x32 don't see each o
Okay I'm answering my own post for anybody else who might need the information. There are two USB inputs/outputs in the back of the Behringer board. Be careful that you plug the usb cable into the card interface and not the remote control interface.
Also, the record latency in menu>settings>record>"Record latency samples" must be set to 4096
Blessings!
Also, the record latency in menu>settings>record>"Record latency samples" must be set to 4096
Blessings!
Who is online
Users browsing this forum: No registered users and 1 guest